Jaunumi

HIGHSIDER license plate holder AKRON-RS PRO incl. license plate light

The HIGHSIDER license plate holder AKRON-RS PRO adapts perfectly to the lines of your bike by its design.

The model-specific bracket of the AKRON-RS PRO allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.

The license plate is made of 2 mm thick sheet steel and precisely cut by laser. After edging still follows the weather-resistant black powder coating.
This ensures the optimal fit and durability.
Through the stepless adjustment you can bring the plate without drilling in the desired position. The plate is held in this position by an additional locking screw.

The AKRON-RS PRO turn signal brackets are adjustable in width and thus suitable for any type of accessory turn signals. This adjustment option allows you to adjust the position for your turn signals to the most diverse license plates. To allow mounting of the turn signals without disconnection from the wiring harness, the M8 through holes are slotted to the side.

Also the position of the reflector you can adjust individually via a slider. Adaptation to the different designs of EU license plates is therefore no problem.

To screw the license plate securely and reduce vibration are included two rubber washers. Another rubber buffer supports the license plate on its underside.

In this PRO version of the AKRON-RS is the very small, milled from high quality aluminum HIGHSIDER license plate light with mounting plate and support arm included. The bracket is adjustable in height and designed to allow mounting in the position required by law.

Details:
- model-specific bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy installation without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixation without further work steps (eg.e.g. drilling)
- easy mounting of the license plate through slotted holes
- license plate light incl. Holder included
- license plate light, E-tested
- infinitely adjustable license plate light
- many different options for mounting the license plate light

Included with the AKRON-RS PRO are:
- Model-specific bracket with mounting parts
- AKRON-RS license plate mounting plate
- Adjustable turn signal brackets
- E-approved reflector with adjustable bracket
- E-approved license plate light
- Mounting instructions

Installation license plate light:
- White = Plus
- Black = Ground

Notes:
- For the original turn signals is optionally available in the accessories tab a special turn signal holder.
- If side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.