Jaunumi

HIGHSIDER AKRON-RS PRO-X license plate holder incl. rear light

The AKRON-RS PRO-X license plate holder adapts perfectly to the lines of your bike thanks to its design.

The model-specific bracket of the AKRON-RS PRO-X allows it to be mounted on the original mounting points of your bike and thus replaced without the need for drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of 2 mm thick sheet steel and precisely cut by laser. After edging, a weather-resistant black powder coating is applied.
This ensures an optimum fit and durability.
The infinitely variable adjustment option allows you to move the panel to the desired position without drilling. The plate is held in this position by an additional locking screw.

The width of the AKRON-RS PRO-X blinker brackets can be adjusted, making them suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. To enable the indicators to be fitted without disconnecting them from the wiring harness, the M8 through-holes are slotted to the side.

You can also adjust the position of the rear reflector individually using a slider. Adaptation to the different versions of EU license plates is therefore no problem.

Two rubber washers are included to securely screw the license plate and reduce vibrations. Another rubber buffer supports the license plate on its underside.

This PRO-X version of the AKRON-RS includes the very small HIGHSIDER rear light milled from high-quality aluminum with mounting plate and carrier arm. The bracket is height-adjustable and designed so that it can be mounted in the legally prescribed position.e.g. drilling)
- Simple mounting of the license plate thanks to slotted holes
- Rear light incl. bracket included in the scope of delivery
- Rear light, E-approved
- Infinitely adjustable license plate light
- Many different options for attaching the rear light

The scope of delivery of the AKRON-RS PRO-X includes:
- Model-specific bracket with mounting parts
- AKRON-RS license plate mounting plate
- Adjustable turn signal brackets
- E-approved reflector with adjustable bracket
- E-approved tail light
- Mounting instructions

Tail light mounting:
- White = license plate light
- Black = ground
- Red = brake light
- White = tail light
- Black = ground

Notes:
- Since the original tail light of your motorcycle is omitted when mounting this license plate holder, we offer you this set including a new tail light and a matching tail light. a new rear light and matching adapter cable.
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.
- We also offer an optional special blinker holder for the original indicators in the Accessories tab.

Tip:
If you haven't found a model-specific license plate holder for your vehicle, you're sure to find one among the universal license plate holders from HIGHSIDER, which are available in many different designs.